The reboiler has been hydroblasted less than a 6 months ago. Any helpful hints or things I can try to get this operating coorectly at the temperatures I need to properly strip the water from the prod

I'm trying to replace/modify a series of valves that reduces pressure from 1600 psi to 400 psi. There is currently one PRV along with an isolation valve in series. Both get steam/condesate cut in a ma

I'm contacting you as I have visit your site on the internet and it might be that you could help or guide me to solve the problems mentioned below.

I am wondering what the best diameter of pipe is for a given volume flow rate. I understand that conductors are sized based on flow velocity, surface roughness etc. but I have read that fluid frictio

Does anyone have typical steam loss rates, which would give me the approximate consumption of steam through a passing steam trap.