I am working on a failure investigation of a control valve in my plant. The valve type is a Fisher 461 Sweep Flow Valve. The valve has been cavitating badly and has caused damage to the valve and do

I'm currently doing pump sizing calculation, so I have to determine the total pressure loss of my piping system. Most of commercial components like ball valves, check valves, strainers, etc. have expe

When looking at the P&ID , I was confused the use of drilled threaded plug or solid threaded plug at the end of drain or vent line. Please advise what occations are suitable for drilled plug.

We are using a triplex plunger pump for pumping 23 cubic meter per hour of water at 40 Kg/cm2 discharge pressure. The suction is from a discharge of a centrifugal pump operating with a discharge press

For well flowlines,if choke collapses there will be an overpressure downstream the choke.I would like to know how many choke failure we have to consider at a time (may be one/two) and which standard r