Hot Product

Product drawing»

Structural drawing»

You are here:Home > Technology > And leverage float type of trap in textile production application

And leverage float type of trap in textile production application

In textile production in the dryer is thick liquid yarn machine adopts baking heat tube. Its principle of work is wet with high-temperature metal tube cross-section surface contact, baked baked tube surface heat transfer surface and sizing, sizing contains moisture constantly vaporization, sizing regain.the decreases, and gradually formed a serous surface sizing. In baking in the surface layer of condensate in baking in the wall, Jane cone lower the condensed water through the parched traps, therefore the trap (traps) proper selection and maintenance is particularly important.
To ensure the baked in condensate can seasonable eduction, usually taken to improve the way, vapor pressure is such a waste of steam, 2 it is safe to use of baking is not guaranteed (because of domestic roasted design work pressure shall not be higher than the 0.36 MPa). Therefore to really good baking supplies of good quality, achieve sizing thick liquid yarn machine, low energy consumption, correct selection trap is crucial, and this is often thick liquid yarn machine manufacturers and use manufacturers overlooked. The trap (traps) in many types of selection, there are two factors which can not be ignored: (1) baked tube vapor pressure may not absolute relative volatility is stable, and traps can adapt to the requirements of the steam pressure changes. (2) thick liquid yarn machine speed is faster speed of change, there are slow there, traps to adapt to different load of water.
State-run 920 factory is specialized in the production of steam trap and leverage float type steam trap (traps) the biggest advantage is not under pressure, temperature, flow of condensate water drain continuously, namely, the minimum degree of 0 °, can make the heating equipment to achieve the best work efficiency, Leverage float type steam trap (traps) seat, total in the level of forming water block to avoid steam leaking, It's the lowest, the maximum working pressure 0.01 Mpa pressure rate than 85%, With exhaust device, internal leverage float type steam trap (traps) adopt the most advanced automatic emptying bellows components as air, can automatically exclude condensate gas, very sensitive, high quality, long service life. Heating equipment most ideal trap (traps).
The state-run 920 on-site experience accumulated, selecting the appropriate steam trap (traps), the correct piping technique, can assist with steam heating equipment to solve slow, water hammer, the condensate not rise, the condensed water recycling technology, save the steam, increased yield, improve quality and saving electricity purposes.

Shanghai MeiYan Yi Pump & Valve Co., Ltd.
MeiYan Yi steam trap valve Contact MeiYan Yi
Shanghai Enine Pump & Valve Co., Ltd.
Enine steam trap valve Contact Enine
Shanghai Saitai Pump & Valve CO., Lid.
Saitai steam trap valve Contact Saitai
Shanghai Fengqi Industrial Development Co., Ltd.
FengQi steam trap valve Contact FengQi